#

AFC Mining Guide

Welcome! This guide is intended to get you mining AFC, a.k.a. "AFC", on the AFC mainnet.The unit for mining is Sol/s (Solutions per second).

If you run into snags, please let us know. There's plenty of work needed to make this usable and your input will help us prioritize the worst sharpest edges earlier. For user help, we recommend using our forum:

Setup

First, you need to set up your local AFC node. Follow the [1.0 User Guide](1.0 User Guide) up to the end of the section "Compiling", then come back here. (You can also do the "Testing" section if you want!)

Mining

Now, start Mining!

$ ./src/AFC

To run it in the background (without the node metrics screen that is normally displayed):

$ ./src/AFC -daemon

You should see the following output in the debug log (~/.AFC/debug.log):

AFC Miner started Congratulations! You are now mining on the mainnet.

To stop the AFC daemon, enter the command:

$ ./src/AFC-cli stop

Spending Mining Rewards

Coins are mined into a t-addr (transparent address), but can only be spent to a z-addr (shielded address), and must be swept out of the t-addr in one transaction with no change. Refer to our 1.0 User Guide for instructions on how to use the z_sendmany command to send coins from a t-addr to a z-addr. You will need at least 4GB of RAM for this operation.

Mining pools

If you're mining by yourself or at home, you're most likely to succeed if you join an existing mining pool. See this community-maintained list of mining pools for further instructions.

P2PKH transactions

The internal AFC miner inherited from Bitcoin used P2PK for coinbase transactions, but AFC 1.0.6 and later use P2PKH by default, following the trend for Bitcoin.

Mine to a single address

The internal AFC miner uses a new transparent address for each mined block. If you want to instead use the same address for every mined block, use the -mineraddress= option available in AFC 1.0.6 and later.